Tapetech 03TT Mini Automatic Taper Manual de usuario descargar pdf (Pagina 2)

Mini Automatic

aper

Operation and Maintenance Guide

“How

Professionals Finish

The

Job”

Revised

Maintenance

This tool must be

washed

with a

brush

and water (or a water hose

)

after each use. Pay close

attention that

all

joint compound

flushed

from under

the

cover

plate and the tape advance

mechanism. Complete the clean-up

by lightly oiling all wear points

Use Ames® Bazooka

Oil or any light machine

oil.

Blade Replacement

1. Hold the key ring, pull down and turn key ring 90

degrees.

Let the key ring slide into the cutter spring

tube.

2. Pull the

cutter

chain until

cutter block

and blade

are

clearly

view.

Loosen

the

cutter block screw

and remove

the used blade

4. Insert a new blade. Tighten the screw, making sure the blade does not

protrude

through the bottom of

the

cutter block

5. Pull the

cutter block

back into the taper head

channel.

6. Pull the key ring down to the end of the spring tube. Turn it 90 degrees and lock it into the original

position.

7. Pull down

on the

control

tube to make sure the

blade travels

freely through

the taper head

channel.

Cable Replacement

Remove

all the mud from the mini

automatic taper

Unscrew

the butt ring from the bottom of the taper tube. Lightly tap tube butt ring with a

screwdriver,

necessary

Remove

the

cover

plate by

taking

out the top screws

and loosening

the side and bottom

screws. Gently

pull

the

cover

plate up and out to

remove

it. Close the gate valve and force the

piston down

with a thin

piece

wood

or a

flattened piece

corner bead.

Loosen

the

screw

on the

cable

drum and remove

the end of the

cable

from the

drum.

Remove

the

cable

from the

piston

removing

the nut from the

slotted stud.

6. Clean the slotted stud of any mud, then thread the cable through the nut while holding it, and place the end

the cable into the slot. Screw the nut onto the slotted stud and tighten, to secure the cable to the

piston.

7. Drop the loose end of the cable into the tube followed by the piston.

Replace

the butt ring and the

screws.

8. Make sure the slot in the

cable

drum is clean and insert the

loose

end of the

cable

and

tighten

the

scr

ew.

Wind

the

cable onto

the

cable

drum by

turning

the drum key

clockwise.

10.

Replace

the

cover

plate and tighten

all

screws.

Gooser Needle Replacement

Holding

onto the gooser needle assembly

loosen the screw and remove the gooser needle. Slide the entire

gooser

assembly

to the bottom of the tape guide. Push the new gooser needle through the hole and out the bottom so

that

the point of the needle protrudes

1/16 inch (1.5mm) through the tape in the slide. Hold the

support assembly and

tighten the screw. Insert tape through the tape guide and check for proper advancement

of the

tape.

1 2

Mini Automatic 1

Comentarios a estos manuales

Sin comentarios

Tapetech 03TT Mini Automatic Taper Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Tapetech 03TT Mini Automatic Taper